首要不是所有的膩子都可以拋光，可以拋光的膩子一般指仿瓷涂料或耐水膩子，施工時先批一遍膩子罩白找平，待其干后用砂紙打磨，然后批二遍待其8成干時用批刀把外表壓平磨出光即可。

Firstly, not all putty can be polished. Putty that can be polished generally refers to porcelain like coatings or water-resistant putty. During construction, first apply a coat of putty to make it white and level. After it dries, use sandpaper to polish it, and then apply two coats. When it is 80% dry, use a trowel to flatten and polish the surface.

1、內墻膩子面層拋光時要把握適宜的拋光時刻，拋光的Z佳時期便是待膩子外表水印消失后，立即進行拋光。

1. When polishing the putty surface layer of the interior wall, it is important to grasp the appropriate polishing time. The best time for polishing is immediately after the watermark on the surface of the putty disappears.

2、產品必定要在保質期內運用，膩子粉廠家提醒如果超過保質期，有必要進行試刮，經檢驗合格后。在施工。

2. The product must be used within its shelf life. The putty powder manufacturer reminds that if it exceeds the shelf life, it is necessary to conduct a trial scraping and pass the inspection. During construction.

3、產品必定要注意防水，應存在在陰涼干燥處，而且保證包封無缺。

3. The product must pay attention to waterproofing, be stored in a cool and dry place, and ensure that the packaging is intact.

4、夏天或高溫氣候條件下，在施刮膩子前建議先用清水潤濕墻面，墻面外表無明水后即可施刮膩子。

4. In summer or hot weather conditions, it is recommended to wet the wall with clean water before applying putty. Once there is no visible water on the surface of the wall, putty can be applied.

膩子粉廠家提醒墻面刮過膩子干了過后出現暗黃狀態,用拋光機拋光一次拋完再用紗紙紗一次,重復三次,最終再用拋光機拋光不必紗紙紗。有沒有拋光,新的拋光有必要用細紗紙500目的加水磨好,膩子刮好今后在七多半干的時分拋光一次,最終在9成干(從旁邊面看的時分有些墻面要干透有點發白)的時分再拋光一次,基本就光了,其實有一般只要進行拋光就會光,只不過要從旁邊面看才顯著,做的好的是又光又滑。

The putty powder manufacturer reminds that if the putty on the wall dries and appears dull yellow, use a polishing machine to polish it once, then use a paper yarn to polish it again, repeat three times, and finally use a polishing machine to polish it without using paper yarn. Is there any polishing? For new polishing, it is necessary to use fine yarn paper with 500 mesh and water to grind it well. After scraping the putty, polish it once when it is about 70% dry, and finally polish it again when it is 90% dry (some walls may dry completely and turn a little white when viewed from the side). It is basically finished. In fact, as long as polishing is done, it will be finished, but it is only noticeable when viewed from the side. What is done well is that it is both smooth and shiny.

膩子粉的分配比較簡略，膩子粉有必要要搭配液體才可以進行分配，現在有很多防水的膩子粉只需要用清水進行分配，運用比較的簡略，還有一種膩子粉的耐水性不是很好，那么就要參加膠水進行分配，可是這種膠水不是很環保，所以膩子粉廠家主張我們在購買膩子粉的時分必定要挑選不需要增加膠水的膩子粉。膩子粉的攪動也是比較重要的，必定要把握好攪動的時刻和力度。膩子充沛的攪拌好今后，要靜置15-20分的時刻，這個過程便是為了讓膩子粉中的增加劑充沛的溶解。

The distribution of putty powder is relatively simple. It is necessary to mix putty powder with liquid before distribution. Nowadays, many waterproof putty powders only need to be distributed with water, which is relatively simple to use. There is also a type of putty powder that has poor water resistance and needs to be distributed with glue. However, this glue is not very environmentally friendly. Therefore, putty powder manufacturers advocate that when purchasing putty powder, we must choose putty powder that does not require additional glue. The stirring of putty powder is also quite important, and it is necessary to grasp the timing and intensity of stirring. After the putty is thoroughly mixed, it should be left to stand for 15-20 minutes to allow the additive in the putty powder to dissolve sufficiently.

膩子粉是建筑裝修材料的一種，首要成分是滑石粉和膠水。剛剛購置的毛坯房外表的一層白色--膩子，通常膩子的白度在90以上細度在330以上。膩子是用來墻面修補找平的一種基材，為下一步裝修(刷油漆貼壁紙)打下杰出的根底。膩子分為內墻和外墻兩種，外墻膩子要抵抗風吹日曬所以膠性大、強度高，環保指數稍低。內墻膩子綜合指數較好，健康環保，所以內墻不外用，外墻不內用。

Putty powder is a type of building decoration material, primarily composed of talcum powder and adhesive. The white putty on the exterior of the newly purchased rough house usually has a whiteness of 90 or above and a fineness of 330 or above. Putty is a substrate used for wall repair and leveling, laying an outstanding foundation for the next step of decoration (painting, pasting wallpaper). Putty is divided into two types: interior wall putty and exterior wall putty. Exterior wall putty needs to resist wind and sun exposure, so it has high adhesiveness, high strength, and slightly lower environmental protection index. The comprehensive index of putty for interior walls is good, which is healthy and environmentally friendly, so it is not used externally for interior walls and not used internally for exterior walls.